How do I test a JFET for Gate-Source Cutoff Voltage on my curve tracer?
Gate-Source Cutoff Voltage - VGS(Off)
(aka Pinch-Off Voltage)
What It Is:
Gate-source cutoff voltage is the VGS necessary to reduce ID to a specified value.
On the curve tracer, VDS is forced by the Collector Supply and VGS is forced by the Step Generator.
What The Display Shows:
The display shows VDS on the horizontal axis and ID on the vertical axis.
Specifications are met when at the specified ID, VGS is within the specified min/max limits.
How To Do It:
1. Set controls:
A: Max Peak Volts to smallest possible value above the specified VDS
B: Max Peak Power Watts to the lowest setting that satisfies (ID x VDS)
C: Horizontal Volts/Div to display VDS between the 5th and 10th horizontal divisions
D: Collector Supply Polarity to +Leakage (N-channel) or -Leakage (P-channel)
E: Vertical Current/Div to display ID between the 5th and 10th vertical divisions
F: Step Generator to Voltage
G: Number of steps to minimum (zero)
H: Step Generator Polarity to apply reverse bias (- for N-channel), (+ for P-channel)
I: Step/Offset Ampl to smallest value possible above the maximum specified VGS
J: Configuration to (Base/Step Gen, Emitter/Common)
K: Variable Collector Supply to minimum % (full ccw)
L: DotCursor ON
2.Apply power to the JFET:
A: Position the Left/Right switch as appropriate
B: Slowly increase the Variable Collector Supply % until the specified VDS is reached
3. Apply gate voltage:
Press Offset Oppose until ID reaches the specified value
4. Compare to data sheet specifications:
Check that at the specified ID, VGS is within the specified min/max limits
常見問答集 ID 52661檢視所有常見問答集 »