DPO7000+DPO70000+DSA70000+VM6000: How do I enable the VGA port to view the scope display on an external monitor?

Question:

DPO7000+DPO70000+DSA70000+VM6000: How do I enable the VGA port to view the scope display on an external monitor?

Answer:

Here is the process to enable the DPO7000 scope display(VGA port)on an external monitor/projector:

  1. Connect the monitor to the SCOPE ONLY VGA port with the scope turned off.
  2. Power on the monitor.
  3. Power on the scope. The external monitor display should have the scope display after the scope boots.
  4. If the scope display is not shown on the monitor, minimize the scope application.
  5. Right-click on the Desktop and select Properties
  6. Go to Settings and click on the Advanced tab (the resulting window should look similar to the one below)
  7. In Displays section make sure Monitor and Panel are setup the same as the screenshot below.

Thumbnail

This FAQ Applies to:

Product Series: Picture Quality Analyzers

Product: DPO7054, DPO7104, DPO7254, DPO70404, DPO70604, DPO70804, DSA70404, DSA70604, DSA70804, DPO7354, DPO71254, DPO71604, DPO72004, DSA71254, DSA71604, DSA72004, VM6000

FAQ ID : 55431

View all FAQs »
下載
下載

下載手冊、產品規格表、軟體等等:

Go to top